Training guides

Noise at Work: UK Regulations and Training Guide

The Control of Noise at Work Regulations 2005 require UK employers to prevent or reduce risks to health from exposure to noise. They set a lower exposure action value of 80 decibels and an upper action value of 85 decibels, averaged over a working day or week, above which specific actions including information, training and hearing protection are required. Noise induced hearing loss is permanent, disabling, and entirely preventable, which is why the law is strict and worth understanding.

Why noise at work matters

Excessive noise at work causes permanent hearing damage that builds up gradually and often goes unnoticed until it is too late to reverse. As well as noise induced hearing loss, exposure can cause tinnitus, a persistent ringing in the ears that can be deeply distressing. Hearing damage is not only a health issue; it affects communication, safety, and quality of life long after a person leaves the job. Because the damage is cumulative and irreversible, prevention is the only effective approach.

The 2005 Regulations explained

The Control of Noise at Work Regulations 2005 require employers to assess the risk to workers from noise, take action to reduce noise exposure where it reaches the action values, provide hearing protection where needed, ensure the legal exposure limit is not exceeded, provide workers with information and training, and carry out health surveillance where there is a risk to health. The emphasis is on reducing noise at source first, with hearing protection as a supporting measure rather than the primary solution.

Lower and upper exposure action values

The regulations set values that trigger specific duties. Understanding them is central to compliance:

  • Lower exposure action value: a daily or weekly average of 80 dB, with a peak sound pressure of 135 dB. At this level employers must provide information and training and make hearing protection available on request.
  • Upper exposure action value: a daily or weekly average of 85 dB, with a peak of 137 dB. At this level employers must reduce exposure by control measures, designate hearing protection zones, and ensure hearing protection is worn.
  • Exposure limit value: a daily or weekly average of 87 dB, with a peak of 140 dB, taking the effect of hearing protection into account. This must not be exceeded.

Who is at risk

Noise risk is common in manufacturing, construction, engineering, woodworking, foundries, agriculture, and entertainment and hospitality venues with amplified music. A simple rule of thumb is that if people have to raise their voices to have a normal conversation when about two metres apart for much of the day, noise is likely to be at a level that requires action. Power tools, machinery, impact processes and compressed air are frequent sources. Even short bursts of very loud noise can be damaging, which is why peak values are part of the regulations.

Reducing noise at source

The regulations require employers to reduce noise exposure by means other than hearing protection wherever reasonably practicable, because controlling noise at source protects everyone and does not rely on individuals wearing protection correctly. Practical measures include using quieter equipment and processes, maintaining machinery to prevent it becoming noisier, fitting silencers or damping, enclosing or isolating noisy equipment, using screens and barriers, and organising work to limit the time people spend in noisy areas. Hearing protection should fill the gap that remains after these measures, not replace them.

Hearing protection: selection and use

Hearing protection such as earplugs and earmuffs reduces exposure but should be a control of last resort, used alongside efforts to reduce noise at source. To be effective it must be suitable for the noise level and the type of work, compatible with any other PPE worn, properly fitted, and actually worn whenever the person is in a hearing protection zone. Over protection can also be a problem, because protection that cuts out too much sound can isolate workers from warning signals and speech, so the right level of attenuation matters. Training in how to fit and care for hearing protection is essential.

What training must cover

Where the lower action value is reached, employers must provide information and training. This covers the risk that noise poses to hearing, the likely noise levels in the workplace and the risks they create, the control measures in place and how to use them, how to obtain, fit and look after hearing protection, how to report defects and problems, and how to spot the early signs of hearing damage. The role of health surveillance should also be explained. Good awareness helps workers take the risk seriously and use the controls consistently.

Noise risk assessments and health surveillance

A noise risk assessment identifies where noise exposure reaches the action values, who is affected, and what controls are needed, using measurements by a competent person where appropriate. The assessment should be reviewed regularly and whenever work or equipment changes. Where workers are regularly exposed above the upper action value, or are otherwise considered to be at risk, the employer must provide health surveillance, usually in the form of audiometric testing, to detect early signs of hearing loss and take action before the damage worsens. Records of assessments, exposure and health surveillance should be kept.

Frequently asked questions

  • What are the noise exposure action values in the UK: A lower action value of 80 dB and an upper action value of 85 dB, daily or weekly averaged, with an exposure limit value of 87 dB.
  • Is noise at work training a legal requirement: Where the lower action value of 80 dB is reached, employers must provide information and training under the 2005 Regulations.
  • What industries have the highest noise risk: Manufacturing, construction, engineering, woodworking, foundries, agriculture, and music and entertainment venues.
  • How do I do a noise risk assessment: Identify where noise reaches the action values, measure where needed, identify who is affected, and put controls and hearing protection in place.
  • Is hearing protection enough on its own: No. Employers must reduce noise at source where reasonably practicable, with hearing protection as a supporting measure, not the primary control.
  • When is health surveillance required: Where workers are regularly exposed above the upper action value or are otherwise at risk, usually involving audiometric testing.

Featherstone Safety Hub stores noise risk assessments, tracks hearing protection and health surveillance, and includes a noise at work course in its awareness training library on the Complete plan.

Start your free 14 day trial of Featherstone Safety Hub.


Assess noise risk and keep the records

Featherstone Safety Hub lets you build and review a noise risk assessment, record the controls and keep survey results in one place. Start a free 14-day trial →

Noise from crushing, drilling and mobile plant is one of the main long-term health risks in quarrying and mineral processing. See mining and critical minerals health and safety consultancy.

This guide gives general information about UK health and safety law. It is not legal advice, and duties remain with the employer and other dutyholders.

Want this handled for your business?

Featherstone Safety gives small businesses across Oxfordshire and the Cotswolds practical, proportionate health and safety support. Compliance reviews start from £395, with the scope and price confirmed in writing first.

See our consultancy services

Prefer to run it yourself? Featherstone Safety Hub keeps your risk assessments, training records and actions in one place from £49 a month per site, with a 14-day free trial.